Technical details

• 6 fuel injector outputs (5A)
• 6 AUX outputs (5A)
• 6 ignition outputs -passive or active coils software selectable (7A)
• 4 stepper motor outputs - bipolar/unipolar (1A)
• 2 EGT direct inputs
• 2 knock sensor inputs
• Inbuilt wide band lambda controller LSU 4.2
• Inbuilt map sensor 400kPa
• Inbuilt baro sensor
• 4 digital inputs VR/HALL – software selectable
• 3 dedicated analogue inputs (TPS, CLT, IAT)
• 4 additional analogue inputs (0-5V)
• compliance with ISO 7637
• support 1-12 cylinders
• max rpm 16000
• injection time resolution 16us
• ignition advance resolution 0,5 deg
• knock sensing 1-20 kHz
• Speed Density, Alpha-N algorithm
• table VE 16x16, resolution 0,1% VE
• ignition table 16x16, resolution 0,5 deg
• AFR Target table 16x16m, resolution 0,1 AFR
• Injector voltage compensation
• coil dwell calibration
• user calibrated IAT, CLT
• PID idle control strategy
• boost control,
• nitro injection control;
• Aux outputs for fuel pumps, rad fan ..
• motorsport strategies launch control, gear dependent shift light, flat shift ( gear change cut)
• logging over 100 parameters
• possibility of check engine lamp
• USB communication no additional interface needed
• user friendly software with free firmware upgrade
• manual and support in English and polish language
• 24 month warranty

PC Requirements:

To properly work with the DET3 device following minimum is required.

• Windows 2000, XP, Vista, Windows 7, Windows 8
• Screen resolution of at least 1024x768 16bit
• CPU with a clock of at least 600MHz,
• USB port.

What is in the box

• ECUMASTER EMU device,
• USB lead
• connectrors,
• set of terminals,
• Laminated pinout in English and Polish.
• Adapter inlcudes: Plug and play adapter box, Connectors to adapter and cables for you to connect the connectors